Step 1: Determine shelf height and mark level line on wall.

Step 2: Locate studs on level line. Closet Master suggests using an electronic stud finder to locate studs. Shelving must be installed into studs to ensure secure shelf support.

Step 3: Insert 3/4" Screw into predrilled hole on side of support. (Must be installed)

Each support is capable of holding 300 lb.

Step 4: Install metal bracket on recessed portion of support with 2" screw as shown.

Step 5: Break Tab for Corner Installation

If support will be installed in corner or flush against wall, break metal tab as shown with a pair of pliers.

Step 6: Attach support to wall on marked level line with supplied 2" screw. Be sure to angle screw slightly downward to ensure drill clears support.

Note: Tighten screw until bracket and screw head are recessed into drywall to allow shelf to fit tight to wall.

Step 7: Using a level, plumb support and install 2-1/2" screw into predrilled hole at bottom of support.

Step 8: Place shelf onto supports and insert 3/4" screws through bracket into underside of shelf as shown.

Step 9: Insert front support screw into predrilled hole as shown.

Note: Square support to shelf as shown.

Step 10: Place self-stick cover caps (supplied) over predrilled holes in supports for clean finish.

OPTIONAL Step 11: Clothing rod brackets are supplied with the rod. Insert brackets into support using predrilled holes. Install rod in brackets

Note: Cut rod ¼” shorter than distance between supports to allow for thickness of rod brackets.